C80 series flange mounted

8 kV Coupler

C80 flange mounted

Design: flange mounted coupler (plug & receptacle)
Contact assignment: 3 phase, 1 ground, 1 pilot
Rated voltage: 8 kV 3 AC
Rated withstand voltage: 26 kV (1 min) dry
Rated current: 250 A, 400 A, 500 A
Short circuit current: 38 kA RMS
Frequency: 50 – 60 Hz
Protection class: IP 67H
Ambient temperature: -40 °C to +45 °C
Shock resistance: IK 10
Sealing: EPDM, potting compound not required
Cable cross section / ø: max. 120 mm² / 21 – 89 mm
Material: sea water resistant aluminum
Surface treatment: nature, polyester powder coating
Dimensions P / R (L x ø): 305 x 267 mm / 343 x 267 mm
Weight Plug / Receptacle: 14,5 kg / 15,3 kg

C-Coupler-Series

  • Optional on request
  • Fiber optic components have been developed to meet military specifications and requirements
  • Three times the crush resistance and twice the tensile strength of non-metallic fiber optic cables
  • Communication is not impacted even if rolled over by a tank
  • Totally rodent proof
  • Pollution resistance – designed for connection and disconnection on site
  • High performance 2,5 mm termini and a split ceramic alignment sleeve assures superior performance and low optical insertion loss even under high shock and vibration
  • Aluminum enclosure with durable anodization
  • Stainless steel version on request
  • APC terminals on request
  • Single mode and multi mode operation possible
  • Configurable design supports from 2 -18 fiber channels per connector
  • Environmental sealing to IP68
Product: Live current insulated cover
Features: Possibility of applying a voltage to the connector even when not plugged in
Design: Male design for C80D1-series
Female design for C80D2-series
Rated voltage Male / Female Pluggable with Patton & Cooke
250 A M C80C1000x 11E-073
F C80C2000x 11E-073A
400 A M C80D1000x C80D3008
F C80D2000x C80D3009
Product: short circuit cover
Features:
  • for shorting and grounding
  • avoidance of capacitive loads
  • in the cable and connectors
Design: plug design for C80D1-series
receptacle Design for C80D2-series
Usage: for C80D-series (400 A)
  • The strain relief entrance fittings are included with the coupler C80 series.
  • The entrance fitting gasket kits are normally not included with the C80 coupler series. For Europe, there are exceptions, so this point must be requested on a case by case basis.
  • The termination kits must be ordered separately with the C80 coupler series.

The termination kit for preparing the conductors consists of: emery paper, shrink tubing, adhesive strap, copper contact tape, contact spring, resin for pressure relief and solvent as well as cleaning cloths.

Data Sheets